LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal Control Switch >> Removal & Installation

Removal & Installation

  1. Remove the seat from the vehicle. See appropriate POWER SEATS article in ACCESSORIES & EQUIPMENT.
  2. At the front underside of the seat cushion, disconnect the power seat control switch and pedal position switch harness connectors.
  3. Pry off the recliner handle.
  4. Remove the screw.
  5. Carefully pull out the outer side shield releasing the two hidden clips (shown) to the inner side shield and the two hidden clips to the recliner mechanism
  6. Remove the outer side shield. Carefully pull out on the side of the outer side shield releasing the clips to the inner side shield and one hidden clip at the side of the seat cushion frame. Carefully pull forward on the side shield releasing the hidden clip at the front of the seat cushion frame. While routing the wiring harnesses out of the seat cushion frame, slide the side shield forward to clear the recliner handle and remove the outer side shield.
  7. Disconnect the electrical connector and push the pedal position switch out of the side shield.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals