LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus LX, 3.0 U >> Repair and Diagnosis >> External Pages >> Different car >> Section 2334 (Engine Emission Control - 2.3L - (Hybrid)) >> Removal And Installation >> Crankcase Vent Oil Separator >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 2.3L HYBRID article.
  2. Remove the 8 bolts, the crankcase vent oil separator and gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
    • Clean and inspect the crankcase oil vent separator gasket and replace if necessary.
scientia non olet · About LEMON Manuals