Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear door push button rod. For additional information, refer to Push Button Rod - Rear, Crew Cab .
- Remove the rear door push button rod linkage. For additional information, refer to Push Button Rod - Linkage, Horizontal, Rear Door, Crew Cab .
- Remove the push button rod bellcrank.
- Remove the rivet mandrel (center).
- Drill out the rivet.
- Remove the push button bellcrank.
- To install, reverse the removal procedure.
CAUTION:
When drilling out the push button rod bellcrank rivet, do not oversize the hole in the door sheet metal.
NOTE:
Use the special tool to install the new rivets.