Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the A/C cycling switch electrical connector.

Fig 1: Identifying A/C Cycling Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the screws and position the suction accumulator aside.
- To install, tighten to 10 Nm (89 lb-in).
Fig 2: Locating Suction Accumulator Aside Screws
Courtesy of FORD MOTOR CO.
Remove the screws.

Fig 3: Removing Screws
Courtesy of FORD MOTOR CO.
Disconnect the electrical connector and remove the blower motor speed control.

Fig 4: Disconnecting Electrical Connector And Removing Blower Motor Speed Control
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.