LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus LX, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2435 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the throttle position (TP) sensor electrical connector.
  2. Remove the 2 screws and the TP sensor.
    • To install, tighten to 3 Nm (27 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals