Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Front turn signal lamp

Disconnect the front turn signal lamp electrical connector.
Rotate the front turn signal lamp bulb holder approximately one-eighth turn counterclockwise and remove from the headlamp assembly.
- Separate the bulb from the bulb holder.

Side lamp

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the 4 fender splash shield bolts.
- To install, tighten to 5 Nm (44 lb-in).
Remove the 4 fender splash shield pin-type retainers.
Remove the screw and position the fender splash shield aside.
Rotate the side lamp bulb holder approximately one-eighth turn counterclockwise and remove from the headlamp assembly.

Fig 1: Front Turn Lamp Bulb Holder

Courtesy of FORD MOTOR CO.

Remove the side lamp bulb from the bulb holder.

Front turn signal lamp or side lamp

To install, reverse the removal procedure.