LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus LX, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2215 (Instrument Cluster System (F250-F550)) >> Removal And Installation >> Instrument Cluster (IC) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Prior to removal of the instrument cluster, it is necessary to upload the instrument cluster configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
  2. Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  3. Lower the steering wheel tilt adjustment to the lowest position.
  4. Remove the 4 screws and position the instrument cluster away from the instrument panel.
    • Disconnect the electrical connectors.
  5. If equipped with column shift, push in the 2 clips and disconnect the transmission range indicator.
  6. To install, reverse the removal procedure.
    • Download the instrument cluster configuration information from the scan tool to the new instrument cluster. For additional information, refer to MODULE CONFIGURATION article.
scientia non olet · About LEMON Manuals