Driver seat

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the safety belt buckle switch electrical connector and separate it from the mounting bracket.

Fig 1: Disconnecting Safety Belt Buckle Warning Indicator Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the front inboard track-to-seat pan bolt.
- To install, tighten to 25 Nm (18 lb-ft).
Fig 2: Locating Front Inboard Track-To-Seat Pan Bolt
Courtesy of FORD MOTOR CO.
Loosen the rear inboard track-to-seat pan bolt to allow removal of the electrical connector.
Pull the wire harness and electrical connector through the seat.

Fig 3: Locating Electrical Connector
Courtesy of FORD MOTOR CO.