LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus LX, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2199 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Cushion - Rear, 60/40, CrewCab >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 60/40 percent rear seat. For additional information, refer to Seat - Rear, 60/40, CrewCab  in this article.
  2. Remove the 2 bolts from the back side of center support.
    • To install, tighten to 50 Nm (37 lb-ft).
  3. Separate the 40 percent seat and the 60 percent seat from the center support.
  4. Remove the screw and the side latch shield.
  5. Remove the screw and the cushion release handle.
  6. Pry the side shield to release the 3 clips and remove the side shield.
  7. Remove the 2 bolts and remove the cushion assembly.
    • To install, tighten to 33 Nm (24 lb-ft).
  8. Remove the bolt and remove the seat cushion latch assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals