LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus LX, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2150 (Rear Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Disc Brake >> Removal And Installation >> Dual rear wheel brake disc

Dual rear wheel brake disc

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The brake disc is part of the hub on all dual rear wheel axle applications.
  1. Remove the wheel bearing and hub assembly. For additional information on the Dana axle, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - DANA article. For additional information on the Ford axle, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 10.50-INCH RING GEAR article
  2. Remove the disc-to-hub bolts.
    • To install, tighten to 121 Nm (89 lb-ft).
scientia non olet · About LEMON Manuals