Removal & Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel pump is located inside left-side frame rail. Open fuel filter/water separator drain valve to release fuel pressure. Disconnect negative battery cable(s). Raise and support vehicle.
- Disconnect fuel pump electrical connector. Remove fuel line retaining clip and disconnect fuel line from fuel pump. Slide retaining clip up on quick connect fitting. Using Fuel Line Disconnect (T90T-9550-S) tool, remove fuel pump delivery line. Remove 2 fuel pump attaching bolts and remove fuel pump and mounting bracket.
- Disconnect fuel pump wiring push pin. Remove pinch bolt from mounting bracket. Remove fuel pump from mounting bracket. To install reverse removal procedure. Install NEW retaining clip on fuel line-to-fuel pump connection. Install and tighten bolts to specification. See TORQUE SPECIFICATIONS .