Removal & Installation
WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, and 2001 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
Brake pressure switch is located on master cylinder. Disconnect negative battery cable. Disconnect harness connector. Unscrew switch. To install, reverse removal procedure. Tighten switch to 13 ft. lbs. (18 N.m). Bleed brake system. See appropriate DISC & DRUM article in BRAKES. Wash any brake fluid from painted or plastic surfaces.