Removal & Installation

Remove the brake pedal and bracket. See BRAKE PEDAL & BRACKET .
Remove the speed control deactivation switch. See Fig 1.
Disconnect the spring. See Fig 2.
Remove the pivot bolt and nut. See Fig 3.
Remove the metal bushing and the brake pedal. See Fig 4.
Remove the spring, the spring bushing and the two inner end bushings. See Fig 5.
To install, reverse the removal procedure.

Fig 1: Removing Speed Control Deactivator Switch

Courtesy of FORD MOTOR CO.

Fig 2: Releasing Spring Tension

Courtesy of FORD MOTOR CO.

Fig 3: Identifying Pivot Bolt Nut

Courtesy of FORD MOTOR CO.

Fig 4: Removing Metal Bushing

Courtesy of FORD MOTOR CO.

Fig 5: Identifying Pivot Bushings

Courtesy of FORD MOTOR CO.