LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1633 (Engine - 6.0L Diesel -- F250-F550 Super Duty 6.0L (99P F450/550)) >> In-Vehicle Servicing >> Engine Mount - LH >> Vehicles with dual generator

Vehicles with dual generator

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rotating Drive Belt Tensioner Clockwise
G03887086Courtesy of FORD MOTOR CO.
  1. Remove the accessory drive belt.
    2. Fig 2: Locating Accessory Drive Belt Tensioner Bolt
    G03887087Courtesy of FORD MOTOR CO.
  2. Remove the bolt and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
    3. Fig 3: Rotating Accessory Drive Belt Tensioner
    G03887088Courtesy of FORD MOTOR CO.
  3. Remove the accessory drive belt.
    4. Fig 4: Locating Bracket And Accessory Drive Belt Idler Pulley Bolts
    G03887089Courtesy of FORD MOTOR CO.
  4. Remove the bolts, bracket and the accessory drive belt idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
    5. Fig 5: Locating Accessory Drive Belt Tensioner Bolts
    G03887090Courtesy of FORD MOTOR CO.
  5. Remove the bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
    6. Fig 6: Locating Wire Retainer And Generator Electrical Connectors
    G03907090Courtesy of FORD MOTOR CO.
  6. Disconnect the wire retainer, generator electrical connector and B+ wire.
    • To install, tighten to 8 Nm (71 lb-in).
    7. Fig 7: Identifying Generator Mounting Bracket Bolts
    G03887092Courtesy of FORD MOTOR CO.
  7. Remove the bolts and generator with mounting bracket.
    • To install, tighten to 47 Nm (35 lb-ft).
scientia non olet · About LEMON Manuals