LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Engine - 6.0L (99P F450/550) Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply Threadlock 262 to the outer circumference of the leading edge of the crankshaft.
    3. NOTE: New seal and wear sleeve must not be separated.
    Fig 1: Identifying Special Tool
    G04648453Courtesy of FORD MOTOR CO.
  3. Using the special tool, install a new oil seal and wear sleeve assembly.
  4. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals