LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Focus ZX3, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Engine Mounts >> Installation

Engine Mounts: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    RH engine mount 

    CAUTION: Clean the engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
  1. Position the RH engine mount and install the 4 bolts.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 1: Installing Bolts
      G04647883Courtesy of FORD MOTOR CO.

    2. LH engine mount 

    CAUTION: Clean the engine mount-to-oil filter adapter and engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
  2. Position the LH engine mount and install the 4 bolts.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 2: Installing Bolts
      G03920884Courtesy of FORD MOTOR CO.

    3. All vehicles 

  3. Lower the engine into position.
    4. CAUTION: Only use hand tools when installing the RH engine mount nut or damage to the engine mount can occur.
    NOTE: RH shown, LH similar.
  4. Install the 4 engine mount nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 3: Identifying Engine Mount Nuts
      G03920590Courtesy of FORD MOTOR CO.
    5. CAUTION: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
  5. Install the transmission mount-to-crossmember nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 4: Identifying Transmission Mount-To-Crossmember Nuts
      G03963913Courtesy of FORD MOTOR CO.
  6. Position the Y-pipe and install the 4 nuts.
    • Tighten to 40 Nm (30 lb-ft).
      Fig 5: Locating Exhaust Manifold-To-Catalytic Converter Nuts
      G03920889Courtesy of FORD MOTOR CO.
  7. Remove the special tools.
    Fig 6: Installing Special Tools
    G04647876Courtesy of FORD MOTOR CO.
  8. If installing the RH engine mount, install the starter. For additional information, refer to STARTING SYSTEM - GASOLINE ENGINES .
  9. Install the upper cooling fan shroud. For additional information, refer to ENGINE COOLING .
  10. Install the generator. For additional information, refer to GENERATOR AND REGULATOR .
  11. Install the throttle body spacer. For additional information, refer to FUEL CHARGING AND CONTROLS - 6.8L (3V) .
  12. Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  13. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals