Injection Control Pressure (ICP) Sensor - Early Build: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Verify the ICP sensor has the O-ring in place.

Fig 1: Installing ICP Sensor

Courtesy of FORD MOTOR CO.

Install the ICP sensor.
Connect the ICP electrical connector.
- Position the heat wrap back over the electrical connector.
  
  Fig 2: Positioning Heat Wrap Back Over Electrical Connector
  Courtesy of FORD MOTOR CO.

NOTE: Engine removed for clarity.

Fig 3: Installing Turbocharger Heat Shield And Bolts

Courtesy of FORD MOTOR CO.

Install the turbocharger heat shield and bolts.
Vehicles with automatic transmission
Partially lower the vehicle. Working from outside the right wheel area, engage the transmission fluid fill tube to the stub tube.
Lower the hoist.
Install the fluid fill tube retainer nut.

Fig 4: Installing Fluid Fill Tube Retainer Nut
Courtesy of FORD MOTOR CO.
Install the transmission fluid level indicator.