LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Focus LX, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2066 (Engine Controls - Symptom Charts (Except Diesel & Hybrid)) >> No Diagnostic Trouble Codes (DTCs) Present Symptom Charts >> Chart 3

Chart 3

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: An extended crank because of a no start may load the exhaust system with raw fuel, damaging the catalytic converter after the engine starts. For vehicles equipped with a secondary air injection (AIR) system, carry out the following after the no start concern is repaired: Disconnect the electric AIR pump relay, run the engine until the surplus fuel is used up, and connect the relay. Disconnecting the relay may set a continuous memory PCM DTC that needs to be cleared.
SYSTEM/COMPONENT REFERENCE (Section 5 Pinpoint Test unless noted)
  1. Add-on Anti-Theft Devices
  1. Visual. CHECK with the customer.
  1. Fuel/Ignition
  1. refer to PINPOINT TEST A - No Start .
  1. Intake Air System (for vehicles equipped with an IAC valve).
  2. If the engine will not start at closed throttle, but will start and run normally at part throttle, check the IAC valve.
  1. refer to PINPOINT TEST KE - Idle Air Control (IAC) Valve .
  1. Exhaust System Restrictions
  1. refer to PINPOINT TEST HF - Catalyst Efficiency Monitor and Exhaust Systems .
  1. Base Engine
  1. REFER to the Workshop Manual Section 303-00, Engine System and carry out the Inspection and Verification to continue diagnosis.
  1. Additional Testing
  1. refer to PINPOINT TEST Z - Intermittent .