Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the OFF position.
- Remove the turbocharger inlet tube. For additional information, refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER article.
- Disconnect the engine oil pressure (EOP) sensor electrical connector.
- Remove the EOP sensor.
- To install, tighten to 12 Nm (9 lb-ft).
- To install, reverse the removal procedure.
CAUTION:
Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.