Trim Panel - Body Side to Roof Moulding: Installation
WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Clean out all remaining sealant from the body side to roof joint and replace with Ford Caulking Cord D6AZ-19560-A or equivalent meeting Ford specification ESB-M4G32-A.
- Position a new body side-to-roof moulding (painted to match) on the vehicle and press into place.
- Install the nuts.
- Install the rear cab corner trim panel, safety belt and rear seat (if applicable).