LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1723 (Engine - 6.0L Diesel -- F250-F550 Super Duty 6.0L (99P F450/550)) >> In-Vehicle Servicing >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Inner And Outer Oil Pump Drive Rotors With Alignment Marks
G03887281Courtesy of FORD MOTOR CO.
    NOTE: Install the gears with marks pointing outward.
  1. Lubricate the inner gear with lithium assembly grease and install onto the crankshaft. Lubricate the outer gear with lithium assembly grease and mesh with the inner gear rotor in the oil pump housing. Wipe off the excess assembly grease.
    2. Fig 2: Locating Oil Pump Body Bolts
    G03887280Courtesy of FORD MOTOR CO.
    NOTE: Install a new O-ring seal.
  2. Install the gerotor cover and bolts.
    • Tighten to 13 Nm (10 lb-ft).
  3. Install the crankshaft front seal. For additional information, refer to Crankshaft Front Seal .
scientia non olet · About LEMON Manuals