LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Excursion 6.8 S, 4WD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System - General Information -- Excursion & F250-F550 Super Duty >> General Procedures >> Lean Correction - Front, F-250 and F-350, 4x2

Lean Correction - Front, F-250 and F-350, 4x2

  1. If lean correction is required, remove the high side front coil spring (5310). For additional information, refer to FRONT - 2WD - EXCURSION, F-250 & F-350 SUPER DUTY .
  2. Compare the height of the original front coil spring with a new one with the same part number. Note the difference.
  3. If the original front coil spring exceeds the height of the new one by 13 mm (1/2 in.), install the new front coil spring in the vehicle. For additional information, refer to FRONT - 2WD - EXCURSION, F-250 & F-350 SUPER DUTY .
  4. If the original front coil spring is shorter than the new one by at least 13 mm (1/2 in.), remove the low side front coil spring from the vehicle. For additional information, refer to FRONT - 2WD - EXCURSION, F-250 & F-350 SUPER DUTY .
  5. Compare all three front coil springs and select the two most evenly matched for installation.
  6. Install the tallest replacement front coil spring on the low side of the vehicle. For additional information, refer to FRONT - 2WD - EXCURSION, F-250 & F-350 SUPER DUTY .
scientia non olet · About LEMON Manuals