LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Excursion 6.8 S, 4WD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System - Excursion & F250-F550 Super Duty >> Removal And Installation >> Wheel Studs >> Removal

Wheel Studs: Removal

  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. On vehicles equipped with dual rear wheels, go to  7.
  4. Remove the disc brake caliper and rotor. For additional information, refer to DISC - EXCURSION, F250-F550 SUPER DUTY PICKUP article.
  5. Remove the rear wheel hub assembly. For additional information, refer to DIFFERENTIALS/DRIVE AXLES article.
  6. Using a suitable press, remove the wheel bolt from the wheel hub and discard.
    Fig 1: Removing Wheel Stud From Hub
    G00371558Courtesy of FORD MOTOR CO.
    7. NOTE: For vehicles equipped with dual rear wheels, use the C-Frame and Clamp Assembly Tool to remove the wheel bolt on the vehicle.
    Fig 2: Pressing Wheel Stud From Axle Flange
    G00370494Courtesy of FORD MOTOR CO.
  7. Remove the wheel bolt from the wheel hub and discard.
scientia non olet · About LEMON Manuals