LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Excursion 5.4 L, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Diesel 7.3L (99F E Series & 99F F450/550)) >> Computerized Engine Controls >> Injector Driver Module >> Removal & Installation (Econoline)

Removal & Installation (Econoline)

WARNING: This page is about a different variant/trim than selected.

Disconnect negative battery cable(s). Disconnect coolant recovery bottle hose. Remove coolant recovery bottle. Remove upper and rear IDM mounting bolts. Loosen lower IDM mounting bolt. Remove IDM. Remove Injector Driver Module (IDM) connector retaining bolt. Unplug harness connector from IDM. To install, reverse removal procedure. Tighten bracket bolts and connector bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals