LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Excursion 5.4 L, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 353 (Manual Transmission, Clutch & Transfer Case - General Information - Excursion & F250-F550 Super Duty) >> Diagnosis And Testing >> Manual Transmission and Clutch >> Clutch Chatter or Shudder Inspection and Verification

Clutch Chatter or Shudder Inspection and Verification

WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford F550 Super Duty, and 2002 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Inspect the engine and transmission mounts for looseness and damage.
    • If the mounts are OK, proceed to the next step in this procedure.
    • If the mounts are loose or damaged, tighten, or install new mounts as necessary. Test the system for normal operation. Proceed to the next step in this procedure, if necessary.
  3. Check for loose bolts that retain the clutch pressure plate to the flywheel.
    • If the bolts are tightened to specification, proceed to the next step in this procedure.
    • If the bolts are loose, tighten the bolts to specification. Refer to CLUTCH . Test the system for normal operation. Proceed to the next step in this procedure, if necessary.
  4. Remove the clutch disc and pressure plate. Refer to CLUTCH . Inspect the clutch disc and pressure plate for wear and damage, and check the clutch disc runout. Refer to CLUTCH PRESSURE PLATE CHECK  and to CLUTCH DISC CHECK . Inspect the flywheel for glazing and damage. Check the flywheel runout. Refer to FLYWHEEL RUNOUT CHECK . Inspect the input shaft for wear, damage and eccentricity. Repair all components as necessary. Test the system for normal operation.
scientia non olet · About LEMON Manuals