Pedal Positioning Switch: Service and Repair

Brake Pedal Control Switch

Removal and Installation
1. Disconnect the battery negative cable.





2. CAUTION: Use care not to damage the instrument panel when removing the headlamp switch.

Using a small screwdriver, pry the headlamp switch from the instrument panel.





3. Disconnect the electrical connectors and remove the headlamp switch.





4. Remove the adjustable pedal switch.
1 Push the adjustable pedal switch out of the instrument panel far enough to access the electrical connector.
2 Disconnect the electrical connector and remove the adjustable pedal switch.
5. To install, reverse the removal procedure.