LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Escape 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1848 (Manual Transmission - ZF S6-650 & M6HD - 6-Speed -- F250-F550 Super Duty (2007)) >> In-Vehicle Servicing >> Output Shaft Seal >> Installation >> Vehicles with four wheel drive (4WD)

Vehicles with four wheel drive (4WD)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, 2007 Ford Cab & Chassis, and 2006 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Output Oil Seal (4X4)
GF0007174Courtesy of FORD MOTOR CO.
  1. Using the special tool, install a new output oil seal.
    • Coat the outer diameter of the new seal with Trim and Weatherstrip Adhesive.
  2. Install the transfer case. For additional information, refer to TRANSFER CASE article.
scientia non olet · About LEMON Manuals