Pinpoint Test B: DTC B1305:01: Notes
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Refer to OEM WIRING DIAGRAMS - REMOTE KEYLESS ENTRY & ALARM for schematic and connector information.
When the alarm system is armed, the Body Control Module (BCM) monitors the hood ajar switch. If the hood is opened while the alarm is armed, the hood ajar switch removes ground from the signal circuit. This signals the BCM that an unauthorized intrusion to the engine compartment has occurred and the BCM activates the perimeter alarm.
- DTC B1305:01 (Hood Switch: General Electrical Failure) - set by the BCM if it detects an open on the hood switch sense circuit. This DTC also sets If the hood Is open during a BCM self-test.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Hood switch
- BCM