Pinpoint Test AU: The Headlamps On Warning Chime Is Inoperative
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- AU1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AU2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AU2 CHECK THE INTERIOR LAMPS OPERATION
- Open and close the driver door.
- Observe the interior lamps.
- Do the interior lamps operate correctly from the driver door?
- Yes : GO to AU3.
- No : REFER to INTERIOR LIGHTING .
- AU3 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- Insert the key into the ignition lock cylinder.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
- Yes : GO to AU4.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AU4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
- Yes
: For DTC U0140:00, GO to PINPOINT TEST BF .
For all other DTCs, REFER to DTC CHART .
- No : GO to AU5.
- AU5 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Check for recorded BCM DTCs from the self-test.
- Are any DTCs recorded?
- Yes : For correct navigation of the DTC, REFER to MULTIFUNCTION ELECTRONIC MODULES .
- No : INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.