LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 3135 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Intake Manifold - Upper >> Removal

Intake Manifold - Upper: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector and wire harness retainers.
  2. Disconnect the coolant hose retainer from the upper intake manifold.
  3. Remove the transmission fluid level indicator tube bolt and the engine oil level indicator tube bolt.
  4. If equipped, disconnect the vacuum hose retainer from the upper intake manifold.
  5. Remove heater inlet tube top retainer.
  6. Remove the 15 bolts and apply outward pressure on metal pipe to remove the upper intake manifold.
    • Cover or tape the opening on the valve covers and lower intake manifold.
    • Remove and discard the gaskets.
scientia non olet · About LEMON Manuals