LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 3135 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Engine Rear Cover >> Removal

Engine Rear Cover: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper oil level indicator and tube. For additional information, refer to Oil Level Indicator and Tube .
    2. NOTE: The upper oil pan must be removed prior to removing the engine rear cover or engine damage may occur.
  2. Remove the upper oil pan. For additional information, refer to Oil Pan - Upper .
  3. Remove the crankshaft rear seal. For additional information, refer to Crankshaft Rear Seal .
  4. Remove the turbocharger downpipe bracket bolt.
    Fig 1: Locating Turbocharger Downpipe Bracket Bolt
    G07480865Courtesy of FORD MOTOR CO.
    5. NOTE: Do not use magnetic screwdrivers or other magnetic tools around the Crankshaft Position (CKP) sensor and the crankshaft sensor pulse ring or damage to the components may occur.
    Fig 2: Locating CKP Electrical Connector
    G07480866Courtesy of FORD MOTOR CO.
  5. Disconnect the CKP electrical connector.
    6. NOTE: To prevent engine damage, replace damaged or missing dowel pins before installing the engine rear cover.
  6. Remove the 10 bolts and the engine rear cover.
    • Remove and discard the engine rear cover gasket.
scientia non olet · About LEMON Manuals