LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2967 (Anti-Theft - Passive Anti-Theft System (Pats) -- F250-F550 Super Duty) >> General Procedures >> Passive Anti-Theft System (PATS) Parameter Reset >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS CHART

G07485410
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
NOTE: This procedure applies to vehicles with and without Passive Anti-Theft System (PATS). For additional information, refer to PRINCIPLES OF OPERATION .
  1. Turn the key from the OFF position to the RUN position.
  2. From the scan tool, enter TOOLBOX. Select BODY - SECURITY - PATS Functions and follow the Integrated Diagnostic System (IDS) on-screen instructions to ENTER SECURITY ACCESS.
  3. From the scan tool, select "Parameter Reset" and follow the IDS  on-screen instructions.
    NOTE: If the Body Control Module (BCM) was replaced on vehicles equipped with PATS  , at least two keys must be programmed to the BCM  . After completing step 3, do not disconnect the scan tool and follow the Erase All Keys and Program Two Keys procedure.
scientia non olet · About LEMON Manuals