Material Specifications
WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Motorcraft® Premium Cooling System Flush VC-1 |
ESR-M14P7-A |
- Once pressure is released, remove the pressure relief cap. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING in this service information.
- Remove the coolant thermostat.
- Install the coolant hose connection without the coolant thermostat.
- Use a cooling system flusher to flush the engine and radiator. Use Premium Cooling System Flush or equivalent.
- Install the coolant thermostat. For additional information, refer to THERMOSTAT in this service information.
- Backflush the heater core, if necessary. For additional information, refer to HEATER CORE BACKFLUSHING in this service information.
- Fill the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING in this service information.
WARNING:
Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in serious personal injury.
NOTE:
Refer to the cooling system flusher manufacturer's operating instructions for specific vehicle hook-up.