LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2952 (Interior Trim & Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Headliner - Regular Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL  in this service information.
  2. Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - REGULAR CAB  in this service information.
  3. Remove the RH and LH sun visor screws and the sun visors.
    • If equipped, disconnect the electrical connectors.
    Fig 1: Locating Sun Visor Screws And Sun Visors
    G07485557Courtesy of FORD MOTOR CO.
  4. Remove the RH and LH sun visor retaining clips.
    • Remove the sun visor retaining clip screws.
    Fig 2: Locating RH And LH Sun Visor Retaining Clips
    G07485558Courtesy of FORD MOTOR CO.
  5. Disconnect the headliner electrical connector located behind the upper B-pillar trim panel.
  6. Fully recline the front seat backs.
  7. Remove the RH and LH garment hooks.
    • Open the garment hook screw covers.
    • Remove the garment hook screws.
  8. NOTE: Make sure not to crease the headliner when removing it from the vehicle.

    With an assistant, remove the headliner through the door opening.

  9. To install, reverse the removal procedure.