Removal and Installation
WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Right side shown in the illustration, left side similar.
- Open the A-pillar trim panel bolt covers.
- Loosen the A-pillar trim panel bolts.
- To install, tighten to 8 Nm (71 lb-in).
-
NOTE: Carefully rotate the A-pillar trim panel during this step.
Remove the A-pillar trim panel.
- To install, reverse the removal procedure.