LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2929 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Ball Joint >> Removal

Ball Joint: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel knuckle. For additional information, refer to WHEEL KNUCKLE  in this service information.
  2. If equipped, remove the ball joint grease fitting.
    Fig 1: Locating Ball Joint Grease Fitting
    G06776407Courtesy of FORD MOTOR CO.
  3. Position the wheel knuckle in a vise and remove the snap ring from the lower ball joint.
  4. NOTE: To avoid damage to the components, do not use heat to aid ball joint removal.

    Using the C-Frame and Screw Installer/Remover and the Ball Joint Remover/Installer, remove the lower ball joint.

    Fig 2: Removing Lower Ball Joint
    G06776408Courtesy of FORD MOTOR CO.
  5. Using the C-Frame and Screw Installer/Remover and the Ball Joint Remover/Installer, remove the upper ball joint.
    Fig 3: Removing Upper Ball Joint
    G06776409Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals