LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2928 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Spindle - F-250, F-350 >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
  1. If installing a new wheel spindle, remove the brake disc and wheel hub assembly. For additional information, refer to WHEEL BEARING AND WHEEL HUB - F-250, F-350 . If the wheel spindle is being removed to service the ball joints, remove the brake pads. For additional information, refer to FRONT DISC BRAKES .
    NOTE: It is not necessary to remove the brake disc and wheel hub assembly when removing the wheel spindle to service the ball joints.
  2. Disconnect the wheel speed sensor electrical connector and detach the sensor harness from the brake hose.
  3. Remove the cotter pin, nut retainer and the tie-rod end nut.
    • Discard the cotter pin.
    • To install, tighten to 115 Nm (85 lb-ft).
  4. Using the Pitman Arm Puller, disconnect the tie-rod end.
    Fig 1: Disconnecting Tie-Rod End Using Pitman Arm Puller
    G06776344Courtesy of FORD MOTOR CO.
  5. Remove and discard the upper ball joint nut and bolt.
    • To install, tighten the new nut to 80 Nm (59 lb-ft).
  6. Remove the existing adjuster sleeve.
    NOTE: Do not allow the camber adjustment sleeve to contact the ball joint seal when installing a sleeve, or damage to the ball joint seal may occur.
    NOTE: All vehicles are built by the assembly plant with a non-adjustable camber/caster sleeve. If service adjuster has been installed, mark position before removal.
  7. Remove and discard the cotter pin, then loosen, but do not remove, the lower ball joint nut.
    NOTE: To prevent damage to the ball joint seal and the ball joint socket, do not use a pickle fork-type remover to loosen the ball joints.
  8. Strike the lower end of the front axle to free the lower ball joint from the axle.
  9. Remove the lower ball joint nut and the front wheel spindle.
    NOTE: Tighten the lower ball joint nut further, if necessary, in order to insert a new cotter pin.
    • Discard the nut.
    • To install, tighten the new nut to 133 Nm (98 lb-ft).
  10. To install, reverse the removal procedure.
  11. Check and, if necessary, align the front end. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .
    NOTE: This step is only necessary if the wheel spindle has been replaced.
scientia non olet · About LEMON Manuals