Removal & Installation

WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.

NOTE: The Pressure Control Solenoid A (PCA) (line pressure solenoid) is not serviced in the vehicle. The solenoid body will need to be removed to remove the PCA . For additional information, refer to SOLENOID BODY ASSEMBLY in this service information.

Remove the transmission fluid pan, gasket and filter. For additional information, refer to FLUID PAN, GASKET AND FILTER in this service information.
Disconnect the affected shift solenoid connector.

Fig 1: Locating Affected Shift Solenoid Connector
Courtesy of FORD MOTOR CO.
Remove the affected shift solenoid.
1. Remove the retaining E clip.
2. Remove the affected shift solenoid.
Fig 2: Identifying Affected Shift Solenoid And Retaining E-Clip
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.