LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2913 (Automatic Transmission 5R110W (TORQSHIFT(R)) -- F450-F550 Super Duty) >> Diagnosis & Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Torque Converter Does Not Apply

Torque Converter Does Not Apply

WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC ROUTINES - TORQUE CONVERTER DOES NOT APPLY

Possible Component Reference/Action
250 - ROUTINE 
Powertrain Control System 
  • CARRY OUT On-Board Diagnostic (OBD) tests. REFER to the INTRODUCTION article for diagnosis and testing of the PCM. For diagnosing TCC  solenoid, GO to PINPOINT TEST A . For diagnosing TFT  sensor, GO to PINPOINT TEST B . For diagnosing TR  sensor, GO to PINPOINT TEST C . For diagnosing OSS  sensor, GO to PINPOINT TEST D . For diagnosing PCA  , GO to PINPOINT TEST E . REPAIR as necessary. CLEAR the DTCs, ROAD TEST the vehicle and RERUN the OBD  test.
  • PCM, vehicle wiring harnesses, transmission internal wiring harness, Pressure Control Solenoid A (PCA), Torque Converter Clutch (TCC) solenoid, Transmission Fluid Temperature (TFT) sensor, Transmission Range (TR) sensor, Output Shaft Speed (OSS) sensor
Incorrect Line Pressures 
  • CHECK pressure at line tap. CARRY OUT Line Pressure Test. REFER to SPECIAL TESTING PROCEDURES  in this service information. FOLLOW the pressure diagnosis test as required.
  • Low pressures
Solenoid Body Assembly 
  • Bolts not tightened to specification
  • TIGHTEN to specification.
  • Filter gasket damaged
  • INSTALL a new filter gasket.
  • Contamination
  • DISASSEMBLE and CLEAN.
  • If damaged or parts are missing, INSTALL a new solenoid body assembly. If misassembled, reassemble correctly.
  • SSPCA  , SSPCB  , TCC  solenoid(s) damaged, misassembled, missing, stuck or bore damaged. Manual valve damaged, misassembled, missing, stuck or bore damaged
Fluid Pump Assembly 
  • Bolts not tightened to specification
  • TIGHTEN to specification.
  • Filter gasket damaged
  • INSTALL a new filter gasket.
  • Porosity, cross leaks, cup plug missing, plugged hole
  • REPAIR as necessary.
  • Pump gears and/or gear pocket damaged
  • INSTALL a new pump.
  • INSTALL a new seal or pump assembly.
  • Control valves, converter charge limit valve, converter pressure regulator valve springs or seals damaged, stuck or not assembled correctly
Torque Converter 
  • REMOVE the transmission. INSPECT for damage. REFER to TORQUE CONVERTER CONTAMINATION INSPECTION  in this service information. If the torque converter fails to pass the criteria for replacement or is damaged, INSTALL a new or remanufactured torque converter.
  • Internal failure preventing the torque converter from applying
scientia non olet · About LEMON Manuals