LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2911 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Oil Pan - Upper >> Removal

Oil Pan - Upper: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil level indicator.
  2. Remove the flexplate. For additional information refer to FLEXPLATE  in this service information.
  3. Remove the oil cooler. For additional information, refer to OIL COOLER  in this service information.
  4. Remove and discard the oil filter.
  5. Disconnect the Engine Oil Temperature (EOT) sensor and Engine Oil Pressure (EOP) switch electrical connectors.
  6. Remove the nut from the oil filter header and position aside the engine wire harness.
  7. Remove the nut and position aside the transmission cooler tubes.
  8. Remove the nut and position aside the side engine wire harness.
  9. Remove the 2 nuts from the front of the engine and position the engine wire harness aside.
    10. NOTE: Do not remove the zero leak plug from the oil pan.
  10. Remove the 25 bolts and the upper oil pan.
    • Remove and discard the gasket.
    • Clean and inspect the sealing surfaces.
scientia non olet · About LEMON Manuals