LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2911 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Oil Cooler >> Removal

Oil Cooler: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to ENGINE COOLING - DIESEL ENGINE article.
  2. Remove the lower oil pan. For additional information, refer to OIL PAN - LOWER  in this service information.
  3. Remove the oil cooler inlet hose.
  4. Disconnect the oil cooler outlet hose at the lower radiator hose outlet. Disconnect the coolant hose retainers from the upper oil pan.
    5. NOTE: Failure to remove the nut from the oil cooler may result in damage to the oil cooler.
    NOTE: The nut is located inside the upper oil pan.
  5. Remove the oil cooler nut.
    6. NOTE: In the event of catastrophic engine failure, always install a new oil cooler assembly. Foreign material cannot be removed from the oil cooler and engine damage may occur.
  6. Remove the 7 bolts and the oil cooler assembly.
    • Remove and discard the gaskets.
    • Clean and inspect the sealing surfaces.
  7. If necessary, remove the oil cooler outlet hose from the oil cooler.
scientia non olet · About LEMON Manuals