LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2911 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> General Procedures >> Push Rod Cleaning and Inspection

Push Rod Cleaning and Inspection

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean each push rod using a suitable solvent. Dry using filtered, compressed air.
  2. Inspect each push rod for wear and deposits which may restrict the flow of oil into the rocker arm assembly. Install a new push rod as needed.
  3. Inspect the ball end of the push rod, if the end does not have a polished look, replace the push rod.
    Fig 1: Identifying Push Rod
    G07480800Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals