LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2911 (Engine Mechanical - 6.7L Diesel -- F250-F550 Super Duty) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Disassembly

Cylinder Head: Disassembly

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the Valve Spring Compressors on the cylinder head.
    Fig 1: Identifying Valve Spring Compressors On Cylinder Head
    G07481244Courtesy of FORD MOTOR CO.
    2. NOTE: It will be necessary to adjust the Valve Spring Compressor as needed to get proper alignment with the valves.
    NOTE: Position the cylinder head on 2 pieces of wood to aid on removing the valves.
  2. Using the Valve Spring Compressor, compress the valve spring and remove the valve stem keys.
  3. Remove the valve spring retainer and valve spring.
    4. NOTE: It may be necessary to file the tip of the valve to aid in removal of the valve from the cylinder head.
  4. Remove the valve.
  5. Remove and discard the valve seal assembly.
  6. Clean and inspect the valves, valve guides and valve seats. Replace components that are damaged or out of specification. For additional information, refer to SPECIFICATIONS  in this service informations.
scientia non olet · About LEMON Manuals