LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2910 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Press the position retaining tabs and rotate the lower cooling fan shroud upward.
    Fig 1: Rotating Lower Cooling Fan Shroud Upward
    G07480038Courtesy of FORD MOTOR CO.
  3. Rotate the tensioner clockwise and remove the accessory drive belt.
    Fig 2: Rotating Tensioner Clockwise
    G07480039Courtesy of FORD MOTOR CO.
  4. Remove the crankshaft pulley bolt and washer.
    • Discard the crankshaft pulley bolt.
  5. Using the Crankshaft Vibration Damper Remover, remove the crankshaft pulley.
    Fig 3: Removing Crankshaft Pulley Using Crankshaft Vibration Damper Remover
    G07480040Courtesy of FORD MOTOR CO.
  6. Using the Crankshaft Front Oil Seal Remover, remove and discard the crankshaft front seal.
    Fig 4: Removing Crankshaft Front Seal Using Crankshaft Front Oil Seal Remover
    G07480041Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals