LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2909 (Engine Mechanical - 6.2L (2V) -- F250-F350 Super Duty) >> In-Vehicle Repair >> Oil Cooler >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Drain the engine cooling system. For additional information, refer to ENGINE COOLING - GASOLINE ENGINES article.
  3. Remove and discard the oil filter.
    • To install, tighten to 16 Nm (142 lb-in).
  4. Disconnect the oil cooler coolant hoses and position aside.
    5. NOTE: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to ENGINE MECHANICAL SYSTEM - GENERAL INFORMATION article.
  5. Remove the threaded shaft and the oil cooler. Inspect the engine oil cooler.
    • To install, tighten to 58 Nm (43 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals