Water-In-Fuel Sensor - 6.4L Diesel: Removal
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- Remove the fuel conditioning module. For additional information, refer to Fuel Conditioning Module - 6.4L Diesel .
- Note the orientation of the water-in-fuel sensor locating guides.
- Using an appropriate tool, turn the water-in-fuel sensor at least 45 degrees counterclockwise.
- Pull the water-in-fuel sensor straight out of the fuel conditioning module.
- Inspect the water-in-fuel sensor for damage. Make sure that there are no pieces broken off of the sensor.
- Remove the screws and manifold cover.
- Clean the inside of the fuel conditioning module, making sure that any loose pieces of the water-in-fuel sensor are removed.
NOTE:
Use care when removing the water-in-fuel sensor. If the sensor is damaged during removal, the fuel conditioning module cover must be removed and the module cleaned to remove any pieces of the damaged sensor.
Vehicles with a damaged sensor