LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2444 (Turbocharger Cooling System -- F250-F550 Super Duty) >> General Procedures >> Fuel and Turbocharger Cooling System Draining, Filling and Bleeding >> Filling and bleeding with RADKITPLUS

Filling and bleeding with RADKITPLUS

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: With the system cold, fill vehicles to within the sight glass on the coolant expansion tank. This fill level will allow for coolant expansion. Overfilling the coolant expansion tank may result in damage to the pressure cap, which can cause the fuel and turbocharger cooling system to overheat.
  1. Install the RADKITPLUS and follow the RADKITPLUS manufacturer's instructions to fill and bleed the cooling system.
    2. NOTE: An operating coolant pump that squeals indicates either:
    • the system is not completely filled or bled.
    • the coolant pump is bad and must be replaced.
  2. If the coolant pump squeals, drain the cooling system, fill and bleed the cooling system again.
    • If the coolant pump still squeals, replace the coolant pump. For addition information, refer to Coolant Pump .
scientia non olet · About LEMON Manuals