LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2436 (Engine - 6.4L 99R Diesel -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Oil Cooler - Body On >> Removal

Oil Cooler - Body On: Removal

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is recommended that this component be serviced with the vehicle body removed. If the body can be removed, refer to Oil Cooler - Body Off .
  1. Remove the intake manifold. For additional information, refer to Intake Manifold - Body On .
  2. Remove the turbocharger pedestal. For additional information, refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER article.
    3. NOTE: Do not discard the oil cooler cover screws. They are self-tapping screws and will be needed to cut the threads in the new oil cooler cover.
  3. Remove the 10 screws and the oil filter base.
    • Remove and discard the press-in-place gaskets.
    • Clean and inspect the sealing surfaces.
    4. NOTE: In the event of catastrophic engine failure, always install a new oil cooler assembly (with oil cooler). Foreign material cannot be removed from the oil cooler and engine damage may occur.
    NOTE: The oil cooler is replaced as an assembly.
  4. Remove the 8 bolts and the oil cooler assembly.
    • Remove and discard the press-in-place gaskets.
    • Clean and inspect the sealing surfaces.
scientia non olet · About LEMON Manuals