Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: To prevent engine damage, always install 4 new bolts when installing the vibration damper.

NOTE: Apply a light coat of engine oil to the bolts prior to installing the bolts.

NOTE: Use the Strap Wrench to prevent the engine from turning during the tightening of the bolts.

Position the crankshaft pulley and install 4 new bolts in 2 stages, in the sequence shown.
- Stage 1: Tighten to 68 Nm (50 lb-ft).
- Stage 2: Tighten an additional 90 degrees.

Fig 1: Installing Crankshaft Pulley Bolts In Sequence

Courtesy of FORD MOTOR CO.

Vehicles with A/C

Install the A/C drive belt.

Fig 2: Locating Belt From Bottom Of A/C Clutch Pulley

Courtesy of FORD MOTOR CO.

All vehicles

Install the accessory drive belt.

Fig 3: Locating Accessory Drive Belt

Courtesy of FORD MOTOR CO.

Install the cooling fan stator. For additional information, refer to ENGINE COOLING article.
Connect the battery LH and RH ground cable(s). For additional information, refer to BATTERY, MOUNTING AND CABLES article.