LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2436 (Engine - 6.4L 99R Diesel -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
  2. Punch 2 holes in the seal.
    3. Fig 1: Punching 2 Holes In Seal
    GF0048504Courtesy of FORD MOTOR CO.
  3. Using the Oil Seal Remover, remove and discard the crankshaft seal.
    4. Fig 2: Removing & Discarding Crankshaft Seal Using Oil Seal Remover
    GF0048505Courtesy of FORD MOTOR CO.
    NOTE: Production seals will not have a wear sleeve. If a service part has been installed, it will have a wear sleeve.
  4. If equipped, using the Crankshaft Seal Remover, remove and discard the crankshaft seal wear sleeve.
    5. Fig 3: Removing & Discarding Crankshaft Seal Wear Sleeve Using Crankshaft Seal Remover
    GF0048506Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals